How to Roll a Windmill

Need help, or have you perfected a revolutionary technique & wanna share it?

Moderator: Moderators

Post Reply
User avatar
Weedguru Higher
Tetrahydrocannabinologist
Tetrahydrocannabinologist
Posts: 14620
Joined: Sun Mar 30, 2003 1:31 pm
Location: Canada
Contact:

How to Roll a Windmill

Post by Weedguru Higher » Sat Mar 13, 2010 9:26 pm

How to Roll a Windmill

A smoke-cooling chamber and multiple joint holder, the Windmill is designed to get you spinning in the breeze. Although it's tricky to make, the holder can be used time and time again.


Roll a wide cone from a 10cm x 10cm piece of cardboard. Secure it with tape then trim the end to form a perfect cone.
Image
Seal the cone with large papers, leaving 3cm of excess paper at the end, as shown.
Image
Carefully make four cross cuts at regular intervals around the end of the cone.
Image
Make a long, narrow roach, about the length of a pencil, and seal it with papers or tape.
Image
Cut the roach in half, then remove a section from the centre of each segment.
Image
Insert the two segments so that the cut-outs are completely inside the cone and facing it's narrow end. Seal any gaps with tape or gummed strips.
Image
Seal the end of the windmill with the excess paper, using thread or tape. To use the windmill, roll the numbers of your choice around the protruding roaches and enjoy a four-way smoke of quixotic proportions.
Image
Image
Image

User avatar
wgToonces
Sir Toke-a-lot
Sir Toke-a-lot
Posts: 2777
Joined: Wed May 04, 2005 8:57 am
Location: Glasgow, Scotland
Contact:

Re: How to Roll a Windmill

Post by wgToonces » Sat Mar 13, 2010 9:30 pm

Ahh I love these :) I remember you used to post em a lot when I was like 15 too haha.
:scratchs:

User avatar
Weedguru Higher
Tetrahydrocannabinologist
Tetrahydrocannabinologist
Posts: 14620
Joined: Sun Mar 30, 2003 1:31 pm
Location: Canada
Contact:

Re: How to Roll a Windmill

Post by Weedguru Higher » Sat Mar 13, 2010 11:55 pm

Ya, I thought so but couldn't find 'em...these aren't really for you guys, they are more for new members
Image

Post Reply

Who is online

Users browsing this forum: No registered users